Revit Architecture Course - Practical Approach (Udemy.com)

I have a problem with the lesson's pausing and skipping into another lesson. I'm not sure if I have to allow buffering time for the video to reframe from skipping (or stopping) or if there was an issue with the recording. Also I'm not sure if the instructor may have made a mistake in editing the video for it to cut off towards the end of a lesson and move on into the next on without finishing up the previous one. Normally there are closing remarks and then a brief introduction to the next lesson. There has been a situation where that didn't happen.
Overall I'm able to follow along with the lesson and have a clear understanding on how to use the program.

perfect awesome course for the beginners

Having already done a few courses, beginner to intermediate I already knew the entire intro.
I liked the part where, you gave a tip with regards to the shortcuts, where if I am in the modify panel, I can just type in the alias, in order to switch command.
Half way through the course and to be honest, I find the teacher a bit confusing " We can put this wall here, yes it's wrong, but we can fix it later" and in many more instances.
I purchased the course and I will finish it, of course, but I don't believe, I will purchase his courses again.

It is good for learning basic revit techniques. So it is a good start, that's all.

Session two you had no building. Then in section three you had a building. How did you draw the building.

yes it was a good course

I Learnt a lot about revit. This will help me dive deeper into the program. Thanks

Yes

so far seems ok.

I liked the course but it could have been edited to clean up the mistakes. There was a lot of back and forth explaining wall placement etc. and never corrected minor issues. I started losing interest when he made mistakes and backtracked those mistakes. It was hard to watch the bonus material also. Making mistakes, back tracking, and "hadn't used revit in months" comments.

superb and lucid

I liked the course but it could have been edited to clean up the mistakes. There was a lot of back and forth explaining wall placement etc. and never corrected minor issues. I started losing interest when he made mistakes and backtracked those mistakes. It was hard to watch the bonus material also. Making mistakes, back tracking, and "hadn't used revit in months" comments.