Learn Caesar II: Piping Modeling & Stress Analysis 2021 (Udemy.com)

Course was good and explained the basics well. I would recommend if more videos can be added considering practical industrial problems and ways to eliminate stress in piping.

Explain the basics so well, but some important topics are missing such as detect the overload stress on pipelines and how to resolve it.

too short, too simple. To avoid stress problems by shorten the length of pipe segments is not really a practical approach from my point of view!

Learned a lot of basics, but didn't like the change of nozzle location at the end. The modification should take in account that the nozzles are fixed, and only the pipe should be modified. All in all was a good presentation on how Caesar II works. Thank you.

This was definitely a good introductory course to CAESAR II, but it might help to go over the topics covered in a bit more depth. I know that it might not necessarily be easy to teach CAESAR II and industry codes and standards at the same time, but it could lead to confusion. I also noticed that the build of CAESAR II that was being used in the videos and the build that I was learning from were probably slightly different (More than likely, I have an older version). This is where additional explanation would be particularly helpful because I was following along fairly well (to my knowledge), and we weren't getting the same error messages/results. It would be nice to know why in order to troubleshoot any problems that may arise.

The course is an introductory course to Caesar II, very useful for the absolute beginners like me.

The English and the explanation is good but the content and the examples are much less than I expected. I would at least like a detailed explanation of the buttons and the modules & menus of the software.

the course was good to refresh my basics for the software, I believe the instructor could have shared more details or at least running stress analysis on 2 or 3 models to cover more potential factors for stress failure. thank you

Yes the course was really beneficial from the point of view my current work scenario. It was basic and was really helpful . Would like to attend the advanced course on this topic as well. Thank you

Course is just brushing through the basics and in detail explanation is not taught. For example, how to give the supports were shown but why to give a particular type of support is not explained. Even the icons on the software ribbon were not explained fully. Pretty disappointed.